6
7
Assembly
Follow the assembly steps in the order listed below.
❶ Remove the nut on the right side of the front
axle and rotate the front axle assembly
completely around until it is facing towards the
center of the body.
❷ Insert the steering column into the axle and
secure with the washer and nut. Rotate each
axle until it is facing outwards and fasten the
nut back onto the axle assembly.
❸ Insert the rear axle completely through the
rear of the rear axle opening in the wheel well.
❹ Attach the left and right rear wheel assembly to
the rear axle.
❺ Attach the left and right front wheel assembly
to the front axle.
❻ Insert the mirrors down into each mirror hole.
❼ Connect the steering wheel wires before
inserting the steering wheel over the end of the
steering column. Secure with nut and bolt.
❽ Insert the tabs of the windshield down into the
holes located on the top of the Ford body.
❾ Insert the rollbar down into the rollbar holes.
❿ Before attaching the seat make the one-time
battery and gearbox connection. (See page 8.)
Place the seat bottom over the seat cavity and
secure with the 2 screws.
⓫ Slide the seat back down into the seat brackets
on each side, and fit the bottom tabs down into
the seat bottom and secure with 2 screws.
⓬ Charge the battery. (See page 9.)
Be sure the gearbox and
wires are completely
inserted through the
gearbox opening.
❶
❷
Insert the hubcap
tabs into the 4 slots
on the wheel inset.
❼
❻
To tighten the wheel bolts, place a
wrench on each wheel bolt and
simultaneously turn the wrenches
in the opposite directions until
the bolts are tight.
❽
❿
⓫
❾
❹
❹
❺
❺
❸
Steering column inserted
with nut and washer
Completely align the holes in
the steering column with the
holes in the steering wheel.
Hold the steering column tight
against the under-body while
attaching the steering wheel.
