Trouble Shooting
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact our Service Center, at
1-909-643-9359
from 9 AM to 5 PM (
PST) Monday through Friday. Or email us [email protected] or
visit us
www.funcreation.net for assistance and information from our trained technical staff. (The
warranty and customer service contact in this manual only apply in the United States and Canada.)
Circuit breaker may "trip" and stop the vehicle if it is overloaded or
the driving conditions too severe. The breaker will automatically
reset after approximately 10 seconds, and the vehicle will operate
normally. To avoid repeated automatic shut downs, do not overload
the vehicle by exceeding the weight limited of 110 lbs (50 kg). Or
by towing anything behind the vehicle. Do not drive up hills or run
into fixed objects, which can cause the wheels to stop spinning
while power is still being supplied to the motors. If breaker
continually trips, please contact our Service Center.
Check all wires and connectors. Make sure that the motor harness
connector is plugged in tightly to the battery, and that there are no
loose wires around the motor.
An old or improperly cared battery may be dead. If you are unsure
whether it is dead or not, you can have it tested at our Service
Center.
A new battery should have been charged for at least 12 hours
before using the vehicle for the first time. After that, it must be
recharge the battery for at least 8-12 hours after each use. Never
charge longer than 20 hours. Check all connectors; make sure the
charger is plugged into the wall outlet. Make sure the power flow to
the outlet is on.
You must have a volt meter in order to tell whether the charger is
working or not. If you think there maybe a problem with the charger,
take it to the our Service Center where they will test it for you.
When exposed to water or moisture, switches can become corroded,
or can jam due to loose dirt, sand or gravel.
Please contact our Service Center for diagnosis and repair.
Check all wires and connectors. Make sure that the motor
harness connector is plugged into the battery tightly, and that
there are no loose wires around the motor.
Circuit breaker may "trip" and stop the vehicle if it is overloaded or
the driving conditions too severe. The breaker will automatically
reset after approximately 10 seconds, and the vehicle will operate
normally. To avoid repeated automatic shutdowns, do not
overload the vehicle by exceeding the weight limited of 110 lbs
(50 kg), or by towing anything behind the vehicle. Do not drive
uphill or run into fixed objects, which can cause the wheels to stop
spinning while power is still being supplied to the motors. If
breaker continually trips, please contact our Service Center.
Trouble Shooting I
16
Summary of Contents for 1700
Page 19: ...12V BATTERY OPERATED RIDE ON ...
