2
Power Harness Routing
1. Disconnect negative battery cable
2. Make sure the supplied fuse is not installed in the fuse holder of the subwoofer power
harness and connect the harness to the stud pictured in Fig. 1. Torque stud nut to 14Nm
(124in-lbs)
3. Route the power harness toward the driver’s side factory firewall grommet and secure with
the supplied wire ties.
4. Make a small incision in the grommet and pass the power harness into the cabin. Fig. 2
5. Install the black two pin power connector on the subwoofer power harness by first inserting
the terminal fully into the connector and then depressing the blue retainer. Fig. 3
Note: Make sure the blue retainer in the
center of the connector is not depressed – it
should be flush with the front of the
connector. If the retainer is depressed, the
terminal will not fully seat in the connector
body. Make sure the terminal is installed into
position 1 on the connector body. There
should be a block-out plug installed in
position 2 in order to prevent the terminal
from being installed into the wrong position
on the connector.
6. ground wire for both the subwoofer and amplifier harness. Fig. 11 Torque to 5Nm
Fig 1
Insert
terminal
first
Then depress
blue retainer
Fig 3
Fig 2
