3
14. Tap the wires using the supplied wire taps. Fig. 5
15. Connect the brown wire of the adaptor harness to the solid white wire. Connect the green wire of the
adaptor harness to the white/brown wire. Fig. 6
Subwoofer Input Connection with Optional Amplifi er
16. Connect the white two pin connector of the amplifi er harness to the corresponding connector of the
subwoofer harness.
Jack Relocation
17. Remove the three bolts securing the jack mounting plate.
18. Move the plate and jack to the passenger’s side rear seat area and push it back until the tool bag touch-
es the front of the seat frames. Make sure the jack mounting plate is oriented the same way it was originally
with two mounting holes toward the rear of the truck and one toward the front. Fig. 7
19. Measure over exactly seven inches from the inside of the seat frame to the edge of the jack mounting
plate. It is important that this measurement be accurate. Mark the three mounting holes with a marker and
then drill a 1/8 inch pilot hole in the center of each of the three mounting holes. Fig. 8
20. Remove the jack and mounting plate and tape the paper template to the carpet lining up the three marks
with the corresponding markings on the template. Fig. 9
21. Cut the carpet along all the dotted lines on the template. When you are fi nished you will have two fl aps,
one large and one small. Pull back the two fl aps and cut away all the carpet insulation beneath. Fig. 10
Fig. 5
Fig. 6
Fig. 7
7 inches
Fig. 8
