Fig. 11
8. Carefully pull the dash panel outward until there is sufficient room to allow access to remove
speaker housing and disconnect wiring.
9. Install the amp/bracket assembly into position as shown in Fig. 7 and secure the top of the
amp bracket using the supplied 10mm bolts.
10. Secure the bottom of the amp bracket using the supplied ¼” screw. Fig. 8
11. Install the sub amp into position by lining up the holes in the amp bracket with the two holes
for the bolts that retained the metal plate. Fig. 9
12. Install the supplied bolt into the bottom hole and leave loose. Fig. 10
13. Using a panel removal tool remove the four plastic retainers (three in front door opening and
one in rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 11
14. Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
Fig. 10
Fig. 9
Fig. 7
Fig. 8
