Adjusting Amplifier Controls
On your Kicker amplifier there are rotary controls and switches on the end panel. These controls ensure the relia-
bility and performance of the amplifier, so they need to be set correctly. If you are using a KX150.4 you will have
two sets of rotary controls and switches. One set controls AMP1 and one set controls AMP2.
BEFORE TURNING ON THE SYSTEM FOR THE FIRST TIME, MAKE SURE THAT
THE ROTARY CONTROLS ON THE SIDE OF THE AMPLIFIER ARE
TURNED FULLY COUNTER-CLOCKWISE!
CROSSOVER SWITCHES
NEVER CHANGE THE CROSSOVER SWITCH SETTING WITH THE SYSTEM ON!
The switches located on the end panel next to the RCA jacks are for setting the internal crossover. In the
OFF
position the amplifier passes a full range signal to the speakers. Use the
LO PASS
position when connected to a
subwoofer. The
HI PASS
position should be selected when connected to any speakers which you do not want to
receive sub-bass information.
KX100.2 & KX200.4 Technical Manual
Version 2.0
Page 9
KX 200.4
KX 100.2
Model
Fuse Size
Wire Size
KX75.2
15A
8 GA
KX150.4
30A
8 GA
Specifications subject to change without prior notice.
Fuse Ratings
