Kicker 19417166, Manual, Page: 4 / 13

4
Fig. 15
12. Connect the gray amplifier harness connector to
the ACM.
13. Disconnect the 28-pin black connector from the
ACM. Carefully cut away approximately 3 inches
of the black cloth wrapping the harness. Find
the green with black strip wire and cut. Strip
back about
¼
inch of wire on each cut end.
Fig.12
See Splicing Technique section
14. Using the supplied butt connectors, connect the harness wire labeled,
“
connector
”
to the cut
wire attached to the ACM connector. Connect the harness wire labeled, “ harness ” to the other
cut wire. Fig. 13 & 14 .
15. Connect the ground wires of both harness to the
ground point located in the right front kick panel
area. Fig. 15 Tighten to 7.5Nm (66in-lb)
16. Remove the four screws securing the front and
rear wire protector and route the subwoofer
harness alongside the factory harness securing
with supplied wire ties. Replace wire protectors.
Fig. 16
17. Remove the two 10mm nuts securing the jack
bracket. Fig. 17
18. Remove the jack tool bag.
Fig. 16 Fig. 17
Fig. 12
Fig. 13
Fig. 14