9
Fig. 17
Fig. 18
12. INSTALLING THE LAMP AND
GLASS SHADE
Lamp
Lamp holder
Wire connector
Light
plate
Glass
shade
metal nut
Glass cap
Decorative nut
Lamp ballast stem
Step 1. Attach the lamp to the lamp holders
applying even pressure to the lamp at each
lamp holder. The lamp will pop into place.
NOTE:
sometimes it helps to open the lamp
holder by lifting the end. This enlarges the
holder allowing the lamp to pop into place
easier. (Fig 17)
Connect the Lamp Ballast to the Lamp by
pushing the Four Pin Connector into the
receptacle on the Lamp.
Step 2. Remove the decorative nut, glass cap
and metal nut from the lamp ballast stem.
Place the glass shade over the lamp ballast
stem and secure the shade with a metal nut
(rubber side touching the shade). (Fig. 18)
Step 3. Fit the decorative glass cap onto the
lamp ballast stem, while holding the
decorative glass cap, thread the decorative
nut onto the lamp ballast stem securely.
DO
NOT OVER TIGHTEN.
