5
6
ASSEMBLY INSTRUCTIONS
(PLUG-IN MOUNTING)
3a. Push wall anchors (FF) through 11/16”
holes drilled in wall (wall anchor (FF) is
completely through wall when a "click" is
heard).
While holding mounting bracket (B) flat
against wall in its final mounting position,
gently pull wall anchor mounting screws
(EE) out and away from mounting bracket
(B) such that wall anchors (FF) are flush
against inside of wall surface, and tighten
wall anchor mounting screws (EE) to
secure mounting bracket (B) to wall
anchors (FF).
Go to Step 5a on Pg. 7
3a
B
7
2a
2a. If NOT mounting fixture on a stud, drill
holes for mounting hardware where
marked in Step 1a. Using a 11/16" drill bit
(not included), drill a 11/16" hole at each
marked location for the wall anchors (FF)
and wall anchor mounting screws (EE).
Remove wall anchor mounting screws (EE)
from wall anchors (FF) and retain. Pass
threads of wall anchor mounting screws
(EE) through mounting hardware slots in
the mounting bracket (B), then thread
them back into wall anchors (FF) as
shown.
NOTE: Wall anchor mounting screws (EE)
should be threaded into wall anchors (FF)
such that 2-3 threads protrude through
wall anchor (FF).
EE
B
FF
Hardware Used
x 2
Wall Anchor
FF
x 2
Wall Anchor
Mounting Screw
EE
EE
FF
