DIMENSIONS
PARTS
2
1
6
3
4
5
Connect and tighten the supply hoses by using
two adjustable wrenches (avoid twisting or
kinking). Turn on the angle valve and check for
leaks.
Note: Do not remove the net filter that
attached into the connecting end!
From below the sink, Slide rubber washer,
metal washer and mounting bracket onto the
thread shank.
Put the rubber O-ring into the bottom gap of
faucets then Insert faucet into faucet hole.
Remove the mounting hardware from the
mounting pipe.
Shut off water suppliers. Remove the old
faucet, clean the mounting surface.
Note: For first time install, flush the pipes
first by open the angel valve to run 60s.
Adjust position of faucet body if necessary,
Then tighten the mounting nuts with phillips
screwdriver until snug.
INSTALLATION
Φ1-3/8”
(Φ35 mm)
Max 1-3/4” (M
ax 45 mm)
1-3/4”
(45 mm)
5-5/8”
(143 mm)
6-11/16”
(170 mm)
9-1/16” (230 mm)
10-7/8” (276 mm)
2-3/16”
(55 mm)
Waterfall- KBF1005
Waterfall- KBF1005
1 Lever Handle
2 Bonnet nut and cap
3 Cartridge
4 Flow Regulators
5 Trim Ring
6 Mounting Bracket
7 Waterlines
8 Fliter
1
4
2
3
5
6
7
8
