KIA Genuine Accessories
Right Angle #2 Phillips Screwdriver and Clip Removal Tool
1
2
N
O
T
E
1. Position the front wheels as needed to access the three (3) Phillips
Screws shown in the drawing.
2. Remove the Center Screw from the Plastic Retainer, then remove the
Plastic Retainer.
3. Remove the three (3) Phillips Screws.
4. Discard the removed hardware.
N
O
T
E
1. Align the mudguard as shown ensuring a proper fit.
3
Right Angle #2 Phillips Screwdriver
4
N
O
T
E
1. Insert one (1) provided Plastic Retainer into the hole as shown.
N
O
T
E
1. While pushing the mudguard up as shown in the drawing, insert and
fasten one (1) Tapping Screw into the upper hole as shown.
2. While pushing the mudguard up as shown in the drawing, Insert and
fasten one (1) Tapping Screw into the inboard hole as shown.
3. While pushing the mudguard up as shown in the drawing,Insert and
fasten one (1) Tapping Screw into the lower hole as shown.
4. Repeat steps 1-4 for the opposite side.
5. Installation is complete.
Make sure to push the mudguard inward during the installation to
eliminate any possible gaps.
After the installation, check for any visible gaps.
If any gap exceeds 1.0mm, loosen the mounting screws and refit the
mudguard to the body to achieve the correct specification.
Be careful not to over-tighten or strip the head of the screw.
Front Mudguard Kit
Revision Date
10/17/2014
Page 3 of 5