Genuine Accessories
1. With A-pill trim partially pulled away, reach behind trim panel and cut
tether clip, as shown above.
Side Cutters
4
N
O
T
E
WARNING: Shock Hazard! Do not touch vehicle's negative battery
terminal to vehicle's positive battery terminal. Serious injury and damage
to the vehicle may occur.
1. Ensure the correct part is being installed. Verify the part number on
the installation orders with the part number on the kit box label.
2. Write down all pre-set radio stations (if applicable).
3. Disconnect and isolate vehicle's negative battery cable.
2
N
O
T
E
N
O
T
E
3
CAUTION: Ensure care is taken to prevent damage to the A-pillar trim
panel, wire harness, sunroof drain tube, and side-curtain airbag.
1. Partially remove the A-pillar trim panel by pulling the top out towards
the vehicle passenger-side, until the A-pillar tether clip catches.
Nylon Panel Removal Tool
1. Carefully pull the front of the driver-side door seal back to allow
removal of the A-pillar trim panel
CAUTION: If needed, use a flashlight to light behind the A-pillar trim to
avoid damaging any vehicle component with the cutting too. DO NOT cut
anything other than the A-pillar tether clip.
N
O
T
E
Ratchet and 10mm Socket
1
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 4 of 17
