2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model RT
Assembly Instructions
Tabletop Support to Columns
Assembly
1. With the foot/column assembly
standing upright on the glides, align
the four holes in one end of the
tabletop support with the four holes
in the small end of the foot/column
(Figure 2).
2. Attach the tabletop support
using four M8 x 20 mm screws,
tightening each screw one quarter
turn at a time in a diagonal pattern
until all four screws are tight
(Figure 2 & Detail A).
3. Attached the second foot/column in
the same manner (Figure 2).
Note:
Before attaching the tabletop
be sure the feet are parallel to each
other and perpendicular to the
tabletop support. If not, loosen the
attachment screws, reposition the
feet and re-tighten the screws.
Base-to-Tabletop Assembly
Note:
The tabletop is pre-drilled for
installation of all components.
1. To avoid scratching the tabletop
place it with the top side down on a
soft, protective surface.
2. Place the tabletop support with
columns on the drilled face of the
tabletop so the heads of the M8 bolts
set into the pockets milled in the
tabletop. The support should now be
flush with the tabletop (Figure 3).
3. Move the tabletop support with
columns slightly to align the holes in
the tabletop with those in the support
(Figure 3).
4. Attach the tabletop support to the
tabletop using #12 x 1” tapping
screws in each available hole
(Figure 3).
Figure 2
tabletop
support
foot/column
assembly
M8 x 20 mm
screws
Figure 3
tabletop
tabletop
support
#12 x 1”
screw
