1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2018 Krueger International, Inc. All Rights Reserved • Code KI-AI-000033/KI/PDF/1118
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Vertical Cable Manager
Assembly Instructions
Vertical Cable Manager Installation
Note:
Cable links assemble with
three options of flexibility depending
on how far each link is inserted
into the next. The farther each link
is inserted, the less flexible the
vertical cable manager assembly will
be. Option one allows for the most
angular variation necessary to loop
and bend as the table height changes.
Option two still allows some flexibility
but exposes less of the cord from
being visible. Option three allows
little flexibility and no cord exposure
(Detail B). The instructions to follow
use option two when assembling the
vertical cable manager assembly.
Your configuration may vary.
1. Position one cable link under the top
mounting plate. Orient the link so
that the power cord from the control
box can be easily routed to the link
wings. Snap the connector end of the
link into the connector holes of the
mounting plate. Continue snapping
connector ends of each link into
the recieving ends of the previous
link until vertical cable manager
assembly reaches the desired length
(Figure 4 & Detail B).
2. Place the anchor in the desired
location on the floor. Snap the
dumbbell connector into the desired
connector holes on the anchor
that the vertical cable manager will
eventually attach to (Figure 5).
3. Take the end of the vertical cable
manager assembly and snap it into
the dumbbell connector on the
anchor (Figure 5).
4. Working from the top of the vertical
cable manager assembly and down,
insert the power cord into each link
by pressing the cord in, between the
link wings. Once the desired amount
of cord has been inserted, slide cable
down through the link assembly
(Figure 6).
Figure 4
tabletop
top
mounting
plate
cable
links
Detail B - Cable Links Degrees of Flexibility
cable links
(option one)
cable links
(option two)
cable links
(option three)
link wings
Figure 5
dumbbell
connector
anchor
vertical cable
assembly
Figure 6
dumbbell
connector
anchor
vertical
cable
assembly
power
cord
link
wings
