Universal Overhead Storage
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
13
Universal Upmount Brackets
1. Determine the height the
Universal cabinet will mount to
the panel using the upmount
brackets. The top of the bracket
will locate the bottom of the
cabinet at that height. For 54” tall
WireWorks panels, locating the
top antidislodgement tooth in the
sixth slot from the top of the frame
(so there is 4
3
/
4
” space to the top
of the panel tile), will position the
bottom of the overhead cabinet at
20” above a 29” high worksurface
(Figure 1, Detail D).
2. If upmount brackets were installed
to the panel frame, disengage
them by pushing up on the
bracket, then rotate the bottom of
the bracket out 30° and pull down
to remove.
WireWorks
Panel tile
Figure 1
upmount bracket
(left-hand)
antidislodgement
tooth
Detail D
upmount bracket
(right-hand)
