2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo
™
Chest, Tower & Vanity
Assembly Instructions
Figure 2
storage unit
(vanity shown)
leg post
(glide)
stem-mount
glide
stem-mount
glide
Glide Installation
1. Thread the stem of each glide into
the threaded insert at the underside
of each leg post. Twist the glides in
clock-wise, fully to the bottom of
the leg post. This will allow level
adjustment of the storage unit if
required when placed in it’s final
location (Figure 2 & Detail B).
2. Once all glides have been installed
to the underside of the leg posts,
carefully turn the unit to the upright
position.
Caution:
The assistance of
a second person is required to turn
larger storage or tower units to the
upright position.
3. Place the storage unit in its final
location. To raise a leg of the unit for
leveling, rotate a glide out as needed.
To lower a low cupboard leg after it
has been raised, turn the glide back
into the leg as needed. Only adjust
the glides as needed to make the low
cupboard level.
stem-mount
glide
leg post
(glide)
Detail B
storage unit
(vanity shown)
