Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Required Tools
• 12 mm Hex Wrench
• Power Drill Driver
• #3 Phillips Tip
• 8” Drill Extension
Note:
Leg posts are designed to
receive either casters or glides,
based on their overall length. Leg
posts at 5
7
/
16
” long are designed for
casters, while 6
3
/
4
” long leg posts
are for glides. If your installation
contains a mix of units with casters
and units with glides, take care to
not mix up the leg components, or
disassembly and re-assembly will be
required to correct the unit heights.
Leg Installation
1. Carefully lay the low cupboard onto a
soft, protective surface on its
back-side.
Caution:
The assistance
of a second person may be required
to turn the unit onto its back
(Figure 1).
2. Align the mounting holes of each
leg post with the mounting holes on
the underside of the storage unit.
Using a power drill driver with 8”
drill extension and #3 Phillips bit,
secure each leg post to the storage
unit using three
1
/
4
-20 x
5
/
8
” machine
screws. Take care to not scratch the
legs with the drill when assembling
the legs (Figure 1).
3. If the storage unit being assembled
is a caster leg unit, go to “Caster
Installation” instructions on this
page. If unit has adjustable glide
legs, go to “Glide Installation”
instructions on the next page.
Caster Installation
1. Thread the stem of each stem-mount
caster into the threaded insert at the
underside of each leg post, making
sure to position the two locking
casters toward the front, user side of
the storage unit and the non-locking
casters at the back. Tighten the
casters to the underside of the leg
post using a 12 mm hex wrench
(Figure 1 & Detail A).
2. Once all casters have been installed
to the caster leg posts, carefully
turn the unit to the upright position.
Caution:
The assistance of a second
person may be required to turn the
unit upright.
Assembly Instructions
Tattoo™ Chest, Tower & Vanity
August 2019
Figure 1
storage unit
(vanity shown)
power drill
driver with 8”
drill extension and
#3 Phillips bit
leg post
(caster)
stem-mount
caster (locking)
stem-mount
caster
(non-locking)
1
5
/ -20 x / ”
machine
screws
4
8
leg post
(caster)
Detail A
stem-mount
caster
leg post
(caster)
storage unit
(vanity shown)
