Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Hiatus
™
Sleeper Bench
Assembly Instructions
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2019 Krueger International, Inc. All Rights Reserved • Code KI-AI-000042/KI/PDF/0519
Tools Required
• Flat Blade Screwdriver
Drawer Tension Adjustment
Note:
The spring roller latch
tension is pre-set at the factory. If
upon installation, the drawer does
not stay sufficiently closed and
more tension is needed, the latch
can be tightened. If the drawer is
too hard to pull open, the latch
can be loosened to ease opening.
1. While the trundle drawer is open,
look underneath the center of the
deck. Locate the bottom end of
the spring roller latch at the rear
end of the trundle drawer. Open
and close the drawer to determine
if it has sufficient tension to
remain closed but is not too hard
to open (Figures 5 & 6, Detail G).
2. The slotted end of the spring
roller latch is the tension
adjustment for the drawer
retention while closed, or
resistance to open the drawer.
Use the flat blade screwdriver
to tighten or loosen the roller
latch tension as needed for the
noted conditions. To increase
the tension, turn the adjustment
screw slot clockwise. To loosen
the tension, turn the adjustment
screw slot counter-clockwise
(Figure 6 & Detail G).
Figure 5
trundle
drawer
center of
drawer deck
spring
roller
Figure 6
Detail G
adjustment
screw slot for
spring roller
latch
trundle
drawer
spring
roller latch
rear
panel
friction
roller latch
Part # 10156
