8. Repeat steps 5, 6 and 7 until all units
are assembled, finishing with the right
end panel.
Note:
two or more
assemblers are recommended when
multiple units are connected.
9. For optional back panel, slide the
back panel into the side grooves of
the assembled units and slide into the
top groove. Insert #8 x
5
/
8
" screws into
the groove directly below the back
panel to keep the panel raised off the
floor (Figures 5 & 6).
10. Carefully tip the shelving unit into an
upright position.
Note:
two or
more assemblers are recommended
when multiple units are connected.
11. Wood Bottom Shelf. Insert (4) metal
pegs into pre-drilled holes just above
the base assembly. Lay bottom shelf
with routed side down and align onto
metal pegs (Figure 7). Repeat for
each unit.
12. 60" and 82" high units require a fixed
center metal shelf. Measure up half
way on the end panels. Within 6" of
this dimension, determine desired
shelf location. Insert (2) metal pegs
into pre-drilled holes at front sides of
end/adder panels at desired shelf
height. At back side of end/adder
panels, insert (2) metal pegs five
holes up from the placement of the
front metal pegs. Set center metal
media shelf onto the pegs. Attach
center shelf to end/adder panel using
three #8 x
5
/
8
" screws and washers per
side (Figure 8). Metal shelves must be
tight against end/adder panel when
screw is fully tightened.
12. Metal media shelves. Insert (2) metal
pegs into pre-drilled holes at front
sides of end/adder panels at desired
shelf heights. At back side of
end/adder panels, insert (2) metal
pegs five holes up from the placement
of the front metal pegs. Set each
metal media shelf onto the pegs
(Figure 7).
13. Optional dividers. Insert metal
dividers into desired slots on each
metal media shelf (six dividers
provided per shelf).
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
Right End Panel
Base Assembly
Back Panel
Side Groove
Figure 5
CrossRoads
®
Metal Media Shelving - Single Face
Assembly Instructions
Wood Bottom Shelf
Base Assembly
Metal Media Shelf
Metal Pegs
(4 per Shelf)
#8 x
5
/
8
" Screws
with two
1
/
4
" Washers
(6 per Fixed Shelf)
Metal Pegs
(2 per Bottom Shelf)
Figure 6
Figure 7
Right End Panel
Base Assembly
Glides (2)
#8 x
5
/
8
" Back Panel
Support Screws (2)
Back Panel
Metal Dividers
Metal Periodical Shelf
Fixed Shelf
Attachment
Screw Holes
Metal Peg
Locations
Screw
Washers
Figure 8
