2
CaféWay
™
Tables - Model ECRCP
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Stool Seat Installation
6. Stools that will be installed near
the pivot point of the table are
required to use all eight mounting
locations. Stools located away
from the pivot location are only
required to use the four outer
corner mounting locations
(Figure 2).
Note:
Enough screws are
supplied to use all eight
mounting locations on each stool
if desired.
7. Remove stools and #14 x
5
/
8
”
attachment screws from the
shipping box. Place stool seats
upside down on a flat protective
surface.
8. Align three screws, two in each
adjoining corner, and one in
between the corners as illustrated
(Figure 3).
9. Install the three #14 x
5
/
8
” screws,
but do not drive the screws in all
the way. Leave a
1
/
4
” gap between
the bottom of the screw head and
stool. This will allow the stool
plate adapter to slide in between
the screw head and seat
(Detail A).
