CaféWay
™
Tables - Models ECELP, ECOCP, & ECRDP
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2018 Krueger International, Inc. All Rights Reserved • Code KI-62654R1/KI/PDF/0718
Optional Middle Bench
Installation
1. Fold table into the storage
position before attachment of
bench can take place (Figure 6).
2. The bench assembly is designed
to span the distance between the
vertical components of the two
middle leg assemblies, which in
the folded position are suspended
in the air (Figure 6).
3. Once the table is in the storage
position, attach the “fixed bench
leg” to the table’s middle leg
assembly. Next, slide the
“non-fixed bench leg” on the
opposite end of bench into
position so that tube can be
inserted inside the upright of
the other middle leg assembly
(Figure 7).
4. Fasten down the bench to the
table leg using a supplied
5
/
16
”
bolt and nylock nut. Tighten
nut and bolt until the nut stops
against the pipe. The parts will
need to rotate during the opening
and closing of the table so make
sure not to over-tighten. Bolt
head must be face away from the
table (Figure 7).
5. Next, align the hole of the
“non-fixed bench leg,” to the
table’s mid leg. Fasten the bench
down to the table leg using a
5
/
16
”
bolt and nylock. Tighten nut and
bolt until the nut stops against
the pipe. The parts will need to
rotate during the opening and
closing of the table so make sure
not to over-tighten. Bolt head
must be face away from the table
(Figure 7).
6. Test table for proper operation.
Figure 6
Figure 7
