7
⁄
16
" carriage bolt
1
⁄
4
-20
nut & washer
CPU
bottom tabs
Figure 4
#8 x
3
⁄
8
"
torx screw
storage hole
slotted bracket
handle
unused
carriage bolts
Figure 5
8. Slide the CPU between the side
panels and allow it to rest on the
bottom tabs. Center the CPU front
to back. For 24" deep work-surfaces,
the CPU must be 1
1
⁄
2
" forward of
center (Figure 4).
9. Press the side panels tightly against
the CPU. Tighten the four
1
⁄
4
-20 nuts
on the slotted bracket and tighten
the nut on the bottom carriage bolt
(Figure 4).
10. Attach the handle to the slotted
bracket with four #8 x
3
⁄
8
" torx head
screws (Figure 5).
Note:
If a security kit is to be
installed to the CPU Holder, this
must be done prior to installing side
panel covers (separate instructions).
See assembly instructions for
Security Kit.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
B a s i c A d j u s t a b l e C P U H o l d e r
A s s e m b l y I n s t r u c t i o n s
3
