3
Pitching your tent/awning
1.
Unroll the tent and peg the four corners
-
we recommend the use of a SPS Footprint to keep the bottom of the
tent/awning clean.
-
Pegging points may need adjusting/tightening once the tent is erected.
2.
Unfold and peg out front porch section, then assemble all roof poles (x5) and feed into pole sleeves.
3.
Starting at the rear of the tent, fix side leg poles into roof pole and lift until pole is stood in place.
Release any tension on the webbing strap at base of the pole and locate pin into pole.
** TIP
-
Prior to lifting poles, unzip side doors to allow air to enter the tent, also giving tent a shake as you lift pole
helps air to enter and prevent the tent vacuuming.
4.
Repeat on remaining poles until tent is completely stood.
Check all Ring & Pins are fixed into bottom of poles and tighten any webbing straps where needed.
