KHIND WM100A, Instruction Manual

Page: 6 / 29

Installation Installation
Outer drain hose installation
Outlet
9 10
1. Insert the outer drain hose into the intake on side of washing machine.
2. Push the outer drain hose into the washing machine, and then fix it by spring ring. Insert the outer drain
hose properly to avoid water leakage.
3. When the washing machine is running, please lay down the outer drain hose and make sure it does not
entangle. The height of drain hose should be lower than 6cm, in order for the washing machine to spin
properly.
Anti-rat bottom board installation
• After installing the washing machine, take out the anti-rat bottom board. Turn upwards the board showing
“up” and insert it from the back side of washing machine. (If the anti-rat bottom board does not insert
completely, it will produce noise when spinning.
• Install the fixed screw in the screw intake.
Lower than 6cm
1 2 3
1. Select the appropriate type of outlet as shown in the figure.
2. End of outlet spout should be more than 10mm, or the connector cannot be assembled.
3. Water leakage is possible from here.
1 2 3
The installation of water inlet hose
1. Unscrewing the part “a” from the water faucet.
2. Respectively attach the water inlet hose to the water faucet.
Note: Do not over tighten. Damage to the valve can result.
3. Run water through both faucet and inlet hose,into a bucket or laundry tub,to get rid of particles in the water
line that might clog the inlet valve screen.
4. Attach the hose connected with the water faucet to the water inlet valve.
Note: Do not overtighten.Damage to the valve can result.
5. Check for leak
• Swing the water inlet hose gently to confirm if it’s suitable.
• Turn on the water faucet and check for leak.A small amount of water might enter the washer. You will
drain this later.
1 2 4