How to Use
8
EN
7
EN
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY PRECAUTION
INFORMATION’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN
THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK
OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
B. Operation when dust barrel is full
1. The dust inside the dust barrel is full. (Fig 1)
2. Press the standby button and the indicator
light goes off. (Fig. 2)
3. Unplug the power cord. (Fig3)
4. Loose clips. (Fig 4)
5. Raise the top cover from the dust barrel.
(Fig 5)
6. Pour out the garbage in the dust bucket.
(Fig 6)
How to Use
A. Operation of vacuuming dust
1. Make sure the power cord is disconnected from the socket
（
Fig 1
）
2. Loose Clips.
（
Fig 2
）
3. Raise the top cover from the dust barrel. (Fig 3)
4. Install Cartridge filter and press tightly on the bottom cap basket. (Fig 4)
5. Place the top cover on a dust barrel, and lock it with both sides of the clips. (Fig5
）
6. Align the hose assembly port with the suction inlet port and insert it into right and tighten it. (Fig. 6)
7. Insert the water inlet pipe into the water inlet of remote control hose and connect the aluminium
extension tube to the remote control hose. (Fig 7)
8. You may connect the aluminium extension tube to increase the operation radius. (Fig 8)
9. Connect the aluminium extension tube with the nozzle that you need. (Fig. 9)
10. Insert the power cord. (Fig 10)
11. Press the standby button and the indicator light on the panel will lights up. (Fig. 11)
12. Press the suction button on the top cover panel or remote control hose, then the machine will start to
work. Suction mode is divided into high and low levels, press the suction button to switch from high to
low level and press again to stop working. (Fig. 12)
C. Operation of water cleaning
1. Make sure the power cord is disconnected from the power supply.
（
Fig1
）
2. Cover the bottom cap basket with water sponge and make sure it cover the entire basket. (Fig 2)
3. Place the top cover on the dust barrel and lock it with both side of clips. (Fig 3)
4. Install the required suction accessories on the aluminium extension tube. (Fig 4)
