Page 5
6.
Intsall lift hook bracket. The tube system
has 3 positions for the lift hook bracket.
Choose best postion for desired lift
height and cable/rope angle.
Position 1
is the default position
allowing more clearance between
winch and bracket
Position 2
uses the same bolt holes,
but in this case the bracket is flipped
over.
Position 3
is used for machines
where the cable is at a severe angle,
such as upper mounted winches. This
position will require longer bolts to
be installed.
7.
The tube system has five positions of
rotation for your blade (Figure 5). Each
adjustment is at 12.5 degree increments.
In order to make each adjustment you
will need to pull on the Pull Pin (Figure
4, Item 4.5) and rotate your blade left or
right until you reach the desired angle.
8.
To attach the tube system to any of our
mounts, position the tube system with
blade installed under your ATV. Raise
tube attach points to the mount and line
up the holes on mount plate with the
holes in the tube system. Insert Safety
Pin (Item 7.3.2) through holes and
secure on other side with clips as shown
in Figure 6.
4.5
POSITION 2
POSITION 1
POSITION 3
“Figure 4” Lift Hook Attachment Positions
“Figure 5” Blade Rotation Angle
25°
12.5°
“Figure 6” Tube System Attachment
7.3.2
