KFI AMP-25, Owner'S Manual And Operating Instructions

Page: 10 / 24

6
AMP-25-R2
This KFI 2,500 lb Plug & Play winch assembly is
designed to be a direct fit up to the specific ATV
Models from our online application chart.
1. On the 850 and 1000 Models remove the
front rack to gain access to the battery.
Disconnect the battery.
2. On the ETX, 450 and 570, open the front
rack and remove the center cover [A] by
removing the (4) Torx fasteners. You will
also need to lightly pull the rubber seal out
of the groove around the center cover to be
removed as shown in Figure 1.
3. Remove any added on bumpers or brush
guards.
4. Remove the lower cowling [B] on the
Sportsman models and the bumper [C] and
front assembly clip [D] on the Scramblers as
shown in Figure 2-5.
5. Remove and discard the Winch pocket
cover [E] shown in Figure 2-5.
6. Remove the winch assembly from the box
and cut the zip tie that is holding the power
wires for packaging.
Step 1-ATV Install Preparation
Installation
Before you start to install this winch,
disconnect the vehicle ground and positive
leads from the battery. ( ETX, 450 and 570
battery is located lower front frame and the
850 and 1000 is located under the front rack
WARNING
Installation
“Figure 2”
ETX, 450 and 570
“Figure 3”
Scrambler
“Figure 4”
850 Sportsman
“Figure 5”
850 & 1000 Sportsman
“Figure 1”
A
B
B
C
D
B
E
E
E
E