TABLE HUBS
(WELDED TO BRACES)
3/8" S.S. FLAT WASHER
3/8" x 2" S.S. HEX
HEAD CAP SCREW
SCREW ASSEMBLY
TYP. 6 PLACES
BRACES
PLEASE READ THESE STEPS BEFORE PROCEEDING
Included with your Easton 6-Seat Table Set is the Following
Hardware:
- Sixty-four (64) 1/2” Stainless Steel Flat Washers
- Thirty (30) 1/2” Stainless Steel Hex Head Nuts
- Thirty (30) 1/2” Stainless Steel Hex Lock Washer
- Thirty (30) 1/2” x 1 1/2” Stainless Steel Hex Head Cap Screws
- Four (4) 3/8” X 1” Stainless Steel Hex Head Cap Screws
- Twelve (16) 3/8” Stainless Steel Flat Washers
- Six (6) 3/8” x 2” Stainless Steel Hex Head Cap Screws
- Six (6) 3/8” Stainless Steel Lock Washers
- Six (6) 3/8” Stainless Steel Hex Head Nuts
ABIDE BY THE FOLLOWING INSTALLATION INSTRUCTIONS
Braces
1. Place braces so plates are approx 60 degrees from each
other.
2. Legs are labeled (B) for bottom, (M) for middle, and (T) for
top.
3. Pick up the brace with marked (M) and place it on top of
brace marked (B). Pick up plate marked (T) and place it on
top of subassembly making sure that the holes in the hubs
line up.
4. Place a 3/8” washer on a 3/8” x 2” cap screw and insert it
through the holes in the hubs.
5. Place 3/8” washer and 3/8” lock washer over threaded end
of cap screw, then add 3/8” nut. Only hand tighten nuts and
bolts on this step.
!
ASSEMBLY INSTRUCTIONS
EASTON 6-SEAT TABLE SET
KEYSTONE RIDGE DESIGNS, INC.
670 Mercer Road | Butler, PA 16001-1840
Toll-free: 1-800-284-8208 | Phone: 724-284-1213
www.keystoneridgedesigns.com
