Keysight U8903B, User Manual

Page: 382 / 605

7 Test Sequence Application
382 Keysight U8903B User’s Guide
Signal analysis
The receiver sensitivity signal analysis settings menu page is displayed as shown in
Figure 7-55 .
Figure 7-55 Receiver Sensitivity > Signal Analysis settings menu page
Init SCPI
Press the Init SCPI softkey to set the SCPI commands that initialize the connected signal generator. You can set the SCPI
command directly or load from a file. This setting is only available if Instrument is set to Other and the Init Instrument is
enabled.
Output Power SCPI
Press the Output Power SCPI softkey to edit the SCPI command that adjusts the RF power of the connected signal
generator. The command must be in the following pattern.
Cmds <val>
Cmds
is the SCPI command and
<val>
is the value that will be filled up by the measurement to perform sweep. For
example,
:POW <val>DBM
. This setting is only available if Instrument is set to Other.
Table 7-52 Receiver Sensitivity > Signal Generation settings menu description (continued)
Menu Description
Table 7-53 Receiver Sensitivity > Signal Analysis settings menu description
Menu Description
Meas Channel Press the Meas Channel softkey to set the measured channel number.
Target SINAD Press the Target SINAD softkey to set the target SINAD value measured from the Meas Channel.
Min 1st Value Press the Min 1st Value softkey to set the minimum first value.
Stop Condition
Press the Stop Condition softkey to select the stop condition.
– Until End
– On Target