Keysight U8903B, User Manual

Page: 307 / 605

Test Sequence Application 7
Keysight U8903B User’s Guide 307
Sub-steps
You can add any number of sub-steps to the measurement. The sub-steps can be enabled,
disabled, or deleted and moved into any order. You can add delay, prompts, and send SCPI
commands to the sub-steps. Press the
Add Sub-Step softkey to add sub-step and press the
up and down arrow keys to select the desired sub-step.
The delay sub-step menu page is displayed as shown in Figure 7-12 .
Figure 7-12 Delay sub-step menu page
Table 7-11 Sub-step menu description
Menu Description
Enable
Press the Enable softkey to enable or disable the selected sub-step. The check box of the sub-step will be selected when
enabled.
Add Sub-Step
Press the Add Sub-Step softkey to add sub-step to the list.
– Delay
– Prompt
– Send SCPI
Delete Sub-Step Press the Delete Sub-Step softkey to delete the selected sub-step.
Edit Press the Edit softkey to move or copy the selected sub-step, or paste a copied sub-step after the selected sub-step.
Settings
Press the Settings softkey to configure the sub-step settings.
– Delay
Set the delay time in seconds.
Minimum: 0 s
Maximum: 3600 s (1 hour)
– Prompt
Refer to “ Prompt sub-step settings ” on page 308 for more information.
– Send SCPI
Refer to “ Send SCPI sub-step settings ” on page 309 for more information.
Properties Press the Properties softkey to rename the sub-step.