Keysight PXB MIMO Receiver Tester, Security Features And Document Of Volatility

Page: 25 / 28

25
Using the Instrument in a Controlled Area
Returning the Instrument to the Controlled Area
Using or Repairing the Instrument in the Non-controlled Area
After the instrument has left the controlled area, to use or repair it in a non-controlled area, you will need a backup
imaged hard drive to install into the CPU Assembly.
Returning the Instrument to the Controlled Area
This section provides detailed steps required to return your instrument to a controlled area after it was repaired or used
outside the controlled area. Follow the applicable procedure listed below:
• If you removed the instrument from the controlled area to use it in a non-controlled area, refer to “After Using the
Instrument in a Non-Controlled Area” on page 26 .
• If you removed the instrument from the controlled area to send it for repair, refer to “After Repairing the Instrument”
on page 26 .
NOTE For instructions on installing and removing the A13 CPU and the A14 Hard Drive Assemblies,
refer to the PXB Guided Service and Support documentation, which is available by selecting the
Technical Support tab at:
http://www.keysight.com/find/pxb
Step Action
1 Before installing the backup hard drive, mark on it the instrument model number and serial number.
It may also be good to mark that it is for the non-controlled area.
2 Remove the CPU Assembly from the instrument.
3 Install the hard drive into the CPU Assembly.
4 Reinstall the CPU Assembly into the instrument.