Keysight P9241, Scpi Programmer'S Manual

Page: 1025 / 1344

:WAVeform Commands
30
Keysight P9241/42/43A Oscilloscopes SCPI Programmer's Guide 1025
:WAVeform:SOURce:SUBSource
(see page 1196 )
Command Syntax
:WAVeform:SOURce:SUBSource <subsource>
<subsource> ::= {{SUB0 | RX | MOSI | FAST}
| {SUB1 | TX | MISO | SLOW}}
If the :WAVeform:SOURce is SBUS<n> (serial decode), more than one data set
may be available, and this command lets you choose from the available data sets.
When using UART serial decode, this option lets you get "TX" data. (TX is an alias
for SUB1.) The default, SUB0, specifies "RX" data. (RX is an alias for SUB0.)
When using SPI serial decode, this option lets you get "MISO" data. (MISO is an
alias for SUB1.) The default, SUB0, specifies "MOSI" data. (MOSI is an alias for
SUB0.)
When using SENT serial decode, this option lets you get "SLOW" data. (SLOW is
an alias for SUB1.) The default, SUB0, specifies "FAST" data. (FAST is an alias for
SUB0.)
If the :WAVeform:SOURce is not SBUS, or the :SBUS<n>:MODE is not UART, SPI,
or SENT, the only valid subsource is SUB0.
Query Syntax
:WAVeform:SOURce:SUBSource?
The :WAVeform:SOURce:SUBSource? query returns the current waveform
subsource setting.
Return Format
<subsource><NL>
<subsource> ::= {SUB0 | SUB1}
See Also • "Introduction to :WAVeform Commands" on page 1000
• ":WAVeform:SOURce" on page 1021