Keysight N9913B, User Manual

Page: 757 / 896

Keysight N9938-90006 User’s Guide 757
System Settings
Preset
— Hold
— is displayed while a single sweep occurs.
How to perform a single sweep while in Hold
1. Press Sweep 3 .
2. Then choose one of the following:
— Single Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
— SA Mode ONLY – With Continuous OFF each successive Run/Hold
press also causes a single sweep.
— Continuous ON OFF Makes continuous sweeps. This is the typical
setting when battery power is not critical.
Preset
The Preset key restores the FieldFox measurement settings to a known
condition. You can preset the entire instrument, or just the current Mode (CAT,
SA, and so forth).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more in “CalReady” on page 127 .
In addition to all Preference settings, the following settings always survive
Preset and Mode Preset:
— External Reference state (see “Frequency Reference Source” on page 789 )
— SA Scale and Units (see “Scale and Units” on page 157 )
— SA Correction states (see “Field Strength Measurements” on page 161 )
— VVM Display Resolution (see “Display Resolution” on page 604 )
— Marker Peak Excursion and Threshold (see “What Is a ‘Peak’” on page 737 )
How to Preset the FieldFox
1. Press Preset .
2. Then choose one of the following:
— Preset Returns ALL Modes to the factory default settings.
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.