Keysight M9485A, Startup Manual

Page: 19 / 43

19
Getting Started
STEP 3. Install the Network Analyzer Modules
Standard Receiver or Direct Access Receiver
Table 1-6 Possible Configuration for Combination of Configurable Test Set (6 Sets) and
Standard Receiver or Direct Access Receiver
NOTE
If you are using other chassis than Keysight’s, you may need a routing for trigger path of
the chassis. Refer to the M9485A FAQ page on the Keysight.com for more information
( http://www.keysight.com/find/m9485A )
2-Way Divider and 4-Way Divider Installation
a. Upon placing all the modules into the chassis, if you are using dividers,
fasten the modules only after alignment plate is installed. Figure 1-10
on page 20 shows the installation of the M9376-60016 4-Way
alignment plate on the modules.
b. Only after the alignment plate is installed, the black plate cover should
be removed. 2-port module have the option of using M9376-60014
2-Way alignment plate.
c. Next, fasten the M9376-62006 4-way divider by ensuring that the
SMP-SMP adapter are fit well through the alignment plate, as shown in
Figure 1-11 on page 21 . 2-port modules have the option of using 3 of
the M9376-62004 2-way divider.Confirm that the screws on 2/4 way
divider are fasten firmly.
d. In the case of Standard Receivers M9376A only, 4-port modules requires
3 of the 4-way divider to be connected. Similarly, 8-port modules require
6 of the 4-way divider and 12-port modules require 9 of the 4-way
divider.
# of Slot #
77A
&
78A
pair
76A 7 8 9 10 11 12 13 14 15 16 17 18
5 1 78A 77A 77A 78A 78A 77A 77A 78A 78A 77A 76A
5 1 78A 77A 77A 78A 78A 77A 77A 78A 76A 77A 78A
5 1 78A 77A 77A 78A 76A 77A 78A 78A 77A 77A 78A
5 1 78A 77A 76A 78A 77A 77A 78A 78A 77A 77A 78A
# of Slot #
77A
&
78A
pair
76A 7 8 9 10 11 12 13 14 15 16 17 18
6 0 78A 77A 77A 78A 78A 77A 77A 78A 78A 77A 77A 78A