Keysight M9185A PXI D/A Converter
M9185A Startup Guide
11
Figure 3
Installing the module to the chassis
5
Hold the module by the injector/ejector handle, and slide
it into an available PXI (or hybrid) slot, as shown in
•
Install the module into the PXI slot of the chassis by
placing the module card edges into the front module
guides (top and bottom).
•
Slide the module to the rear of the chassis and assure
that the injector/ejector handle is pushed down in the
unlatched (downward) position.
•
Slide the module completely into the chassis.
•
When you begin to feel resistance, push up on the
injector/ejector handle to fully inject the module into
the chassis.
6
If you are using a remote controller, install the System
Interface Card in the chassis.
7
Latch the module by pulling up on the injector/ejector
handle and secure the front panel to the chassis using the
module front- panel mounting screws.
8
Tighten the screws on the module (or remote controller)
front panel. Performance may suffer if the screws are not
tightened properly.
9
Verify that the PXI chassis fans are operable and free of
dust and other contaminants that may restrict airflow.
