Keysight M5300A, Startup Manual

Page: 74 / 80

74 M5300A PXIe RF AWG Modules Startup Guide
4 Troubleshooting and Safety information
Section 4.3: Troubleshooting issues with PathWave FPGA
4.3.1: Module-specific BSPs not installed
If the BSP file for either of the supported modules is not installed, the
KF9000B PathWave FPGA SW prompts the error shown in Figure 34 , when
you try to create a new project.
Figure 34 Error prompted by PathWave FPGA SW if BSP is not installed
To fix this issue, install / reinstall the SW drivers for the required driver.
See Installing required software on page 54.
4.3.2: Xilinx Vivado tool not installed
If you do not have the Xilinx Vivado Design Suite on the same machine
where the KF9000B PathWave FPGA software and BSP are installed, the
following error is prompted, when you click the Generate Bit File... icon.
Figure 35 Error prompted by PathWave FPGA SW if Vivado is not installed
In such cases, contact Xilinx support or download Vivado Design Suite
from https://www.xilinx.com/ .