Keysight ixia UHD100T32, Getting Started Manual

Page: 28 / 48

You can also adjust the rear-post bracket ears to fit different rack depths from 56 cm to 85 cm.
The following image illustrates the steps:
CAUTION: Installing the device in a rack requires two people. One person should position
the device in the rack, while the other secures it by using the rack screws.
ATTENTION: L’installation de l’appareil dans un rack nécessite deux personnes. Une
personne doit positionner l’appareil dans le rack, tandis que l’autre le fixe à l’aide des vis du
rack.
Ground the chassis
To ground the chassis, do the following:
1. Ensure that the rack on which the system is to be mounted is properly grounded and in
compliance with ETSI ETS 300 253. Verify that there is a good electrical connection to the
grounding point on the rack (no paint or isolating surface treatment).
2. Attach a lug (not provided) to a #18 AWG minimum grounding wire (not provided), and connect it
to the grounding point on the system rear panel. Next, connect the other end of the wire to rack
ground.
The following image illustrates the steps:
Chapter 4 How do I...
– 15 – 913-2626-01