Keysight InfiniiMax III+ Series, User Manual

Page: 77 / 162

Maintaining Probe Heads
3
InfiniiMax III+ Series Probes User’s Guide 77
Figure 61 Clamping the Part
2
Grab each resistor lead or wire with tweezers and pull very gently up. Touch the
soldering iron to solder joint just long enough for the resistor to come free of
the probe head tip.
Figure 62 Removing the Resistor
NOTE
Clean the soldering iron tip of any excess solder before using.
NOTE
The solder joint has very low thermal mass so the joint will quickly melt and release.
CAUTION
To limit burning and damage to the PC board, do not keep the soldering iron in contact
with the tip any longer than is necessary.
CAUTION
Excessive dwell time with the iron will permanently damage the flip-chip resistor.