Keysight E6650A EXF, User Programming Manual

Page: 467 / 657

6 List Sequence Measurements
Meas Setup
Initial S/W Revision A.11.50
Help Map ID 35338
Trig Holdoff
This parameter sets the trigger holdoff time and state. When the state is On, then the trigger only occurs
after holdoff time expires (if the trigger condition is satisfied during the time span). The trigger condition is
defined by
"Holdoff Type" on page 467 .
parameter_table_23.52941
52.94118
Key Path
Meas Setup, Input Trigger Setup, Trigger Holdoff
Remote Command :TRIGger:LSEQuencer[:SEQuence]:HOLDoff <time>
:TRIGger:LSEQuencer[:SEQuence]:HOLDoff?
:TRIGger:LSEQuencer[:SEQuence]:HOLDoff:STATe OFF|ON| 0|1
:TRIGger:LSEQuencer[:SEQuence]:HOLDoff:STATe?
Example :TRIG:LSEQ:HOLD 500ms
:TRIG:LSEQ:HOLD?
Example :TRIG:LSEQ:HOLD:STAT 1
:TRIG:LSEQ:HOLD:STAT?
Preset 0s
Off
State Saved Saved in instrument state.
Range 0s to 4s
Min 0 s
Max 4 s
Initial S/W Revision A.11.50
Help Map ID 35339
Holdoff Type
Lets you set the Trigger Holdoff Type (Above or Below).
•
Above: If the trigger slope is positive, a trigger event is generated only if the signal characteristic of
interest crosses the trigger threshold (with positive slope) and then remains above the threshold for at
least the holdoff time. For negative slope, the trigger event is generated if the signal characteristic
crosses the threshold (with negative slope) after having been above the threshold for at least the holdoff
time. In either case, the trigger event is associated with the time the level was crossed.
•
Below: If the trigger slope is positive, a trigger event is generated only if the signal characteristic of
interest crosses the trigger threshold (with positive slope) after having been below the threshold for at
least the holdoff time. For negative slope, the trigger event is generated if the signal characteristic
Sequence Analyzer User's & Programmer's Reference 467