Keysight E5080A, Installation Manual

Page: 25 / 32

Troubleshooting
2
Network Analyzer 23
System Recovery
By executing system recovery, you can return the E5080A’s
system (the Windows operating system and the firmware) to the
factory state (at the time of purchase
*1
).
Notes on executing the factory recovery function
Executing the factory recovery function causes the following
conditions:
• In addition to the Windows operating system and the firmware,
the following settings of the E5080A are returned to the factory
state.
• Network setting
• GPIB setting
• Printer setting
• The driver for the supported printer which is installed after
purchase is deleted.
• You need to execute initial registration again.
Files that you have created using the save function (files in the D
drive) are not affected. However, Keysight recommends backing
them up before executing system recovery for precautionary
purposes. For more information on backup, refer to “Backing Up
the Data” as described in E5080A Online Help .
Procedure to execute the factory recovery
This section describes how to return the contents of the C drive to
the factory state.
* 1. The default setting of the hard disk is recovered during the system recovery.
For the hard disk that had failed earlier and had been replaced (after
purchase), its default setting may not be the same as the factory state.
C A U T I O N
Strictly follow the steps described below. If you do any
operation other than the following steps, the system may
not be recovered.
N O T E
You need a keyboard for this operation.