Setting Up the Keysight 5500 SPM
5
Keysight 5500 SPM User’s Guide
5-10
2
Use wrench to detach latch attachment screws (
). Note
orientation of latch parts. Keep screws and latch parts for subsequent
reattachment.
Figure 3-7
Latch with latch attachment screws
3
Support weight of enclosure door from below. Use wrench to detach
screws which attach the hinge to the enclosure body. Remove door.
4
Use wrench to detach hinges from door. Attach hinges to enclosure
body on opposite side.
5
Put enclosure door back into place and support weight from below.
Use wrench to attach hinge to door.
6
Use wrench to reattach door latch and to reattach fill screws.
Managing Cables
There are cable ports on both sides of the enclosure. Before installing
instrument, select which side of the enclosure the instrument cables
should be ported through. If necessary, remove port cover and place in
port which will not be used.
1
Remove damping foam from cable port to be used. Feed instrument
cables out through port.
2
Outside of enclosure, compress two pieces of damping foam around
cables. Push foam and cables into cable port.
3
Adjust as necessary to ensure a good seal around the cables, as
shown in
