Keysight U4431A MIPI M-PHY Protocol Analyzer Hardware and Probing Guide
29
Setting up a U4432A SMA Differential Probe Configuration
2
Labeling the Probes
A label sheet is provided with the U4433A probe shipment. Use this label sheet to place the pod and
channel labels on the U4433A probe as follows:
1 Place the Pod label on the module connector of the probe that you plugged into the Analyzer
module’s Pod input.
2 Place the channel label on the space provided on the block in the cable housing of the probe.
3 While placing these labels, match with the color coding of the label on the Analyzer module’s
Pod input location in which you plugged the probe.
The following figure displays a U4433A probe’s module connector and cable housing block with
Pod and channel labels placed.
Figure 11
U4433 Channel Label and Pod Label
NOTE
Be careful while plugging in or out a flying lead cable from the soldered ZIF Tip.
While detaching a module connector from the U4431A module, disengage the screws completely
from the module and then pull the module connector straight out to remove.
CAUTION
Components on the U4433A probe are sensitive to the static electricity. Therefore, take necessary
anti-static precautions, such as wear a grounded wrist strap, to minimize the possibility of
electrostatic damage.
