Keysight Technologies U3022BH10, User'S And Service Manual

Page: 22 / 124

System Configurations U3022BH10
System Configurations
The Keysight U3022BH10 High Power Test Set can be configured for many applications.
Included in this document are four typical configurations:
•
System Setup, 14 Ports" on page 2 3
•
System Setup, 14/24 Ports with U3020AH37" on page 31
•
Figure 57 , “1 Watt High Power Configuration” on page 70
•
Figure 58 , “20 Watt High Power Configuration” on page 70
Refer to section, “High Power Measurements” on page 63 .
The internal firmware of the Keysight N5242A /B PNA-X Series Network Analyzer
has not been modified for this Test Set option. Power levels may differ from
those indicated on the PNA-X when the Test Set is connected.
Refer to the configuration diagrams for external component connections and/or
operating constraints when utilizing the high power capability. External
components are not supplied with the high power Test Set. See
Figure 57 and
Figure 58 on page 7 0 , and Figure 59 on page 71 and Figure 6 0 on p age 7 2 .
The high power Test Set is equipped with receiver access ports. The jumpers can
be removed to insert attenuators that will reduce the RF power to the PNA-X A,B
and R channel receivers. Recommended power levels to the PNA-X receiver
ports is –15 dBm. Refer to your PNA-X specifications to optimize power levels to
the receiver ports.
Prior to powering-up the booster amplifier it is highly recommended that the
user verify the RF power levels seen by the various elements of the Test Setup.
Both the PNA-X and Test Set power levels must be taken into consideration. At
high power levels, a mistake could damage the instruments. Accordingly, the
following key values are given in
Table 5 on page 16 .
22 U3022BH10 User's and Service Guide