Keysight Technologies U3022AH10, User'S And Service Manual

Page: 81 / 92

U3022AH10 Troubleshooting the Test Set
Source Signal Path Insertion Loss Test
Connect the RF Flex cables to the Front Panel Test port and Source IN access port indicated in
Table 20 below. Check that the results are similar to Figure 61 below.
RF Path Description
Control Mode Entry
<address>.<data>
Insertion Loss
(Typical)
Source OUT to Port 3 1 0.1 (0.113) 2
Figure 61
Source OUT to Port 5
Source OUT to Port 7
Source OUT to Port 9
Source OUT to Port 11
Path
#
0.2 (0.114)
0.3 (0.115)
0.4 (0.116)
0.5 (0.117)
Odd Ports
Path Components
1
2
3
4
5
Source OUT to Port 4 16.1 (16.113)
Figure 61
Source OUT to Port 6
Source OUT to Port 8
Source OUT to Port 10
Source OUT to Port 12
16.2 (16.114)
16.3 (16.115)
16.4 (16.116)
16.5 (16.117)
Even Ports
6
7
8
9
10
1. Use the Source IN port associated with this group of test ports.
2. Standard model source control codes.
P3 CPLR, S10
P5 CPLR, S10
P7 CPLR, S10
P9 CPLR, S10
P11 CPLR, S10
P4 CPLR, S20
P6 CPLR, S20
P8 CPLR, S20
P10 CPLR, S20
P12 CPLR, S20
Figure 61 Source OUT to Ports 3-12 Path Response
Table 20
Source Signal Path Test Instructions
U3022AH10 User's and Service Guide 81