Installation Note E8356-90001 11
In This Guide
Installing Your Analyzer
Install Spyware Protection
There is no anti-spyware software installed on the instrument. This should not
be a problem if you do not use the instrument for a lot of internet browsing.
Having spyware in the instrument could have an impact on the instrument
performance.
See also,
“Windows 10 Operating System (B Models Only)” on page 22
Use AgileUpdate
If your PNA is connected to the Internet, use AgileUpdate to obtain the latest
firmware. On the PNA, press System, then [Service] softkey, then [AgileUpdate]
to automatically update your firmware to the current revision.
If your PNA is NOT connected to the Internet, you must update firmware using
a flash drive. Firmware can be downloaded from
http://na.support.keysight.com/pna
Installing Your Analyzer
Overview of the Installation Procedure
“Step 1. Check the Shipment.”
“Step 2. Meet Requirements.”
“Step 3. Install the Analyzer.”
“Step 4. Connect the Accessories.”
“Step 5. Install Ferrite Cores.”
“Step 6. Start Up the Analyzer.”
“Step 7. Perform Administrative Tasks.”
“Step 8. Run the Operator's Check.”
“Step 9. Turn Off the Analyzer.”
This procedure requires an open or short calibration standard that mates
with the front panel test ports. The open or short calibration standard is
NOT included with the PNA.
