22
Keysight P9241/42/43A Oscilloscopes Startup Guide
5
Connecting the Oscilloscope
When used for the 10 MHz reference output signal, the amplitude is 5 Vpp into a
high impedance or 2.5 Vpp into 50 Ohms. It is capable of driving into lower
impedances, but the output will be reduced because of the 50 Ohm source
impedance.
For information on using Ref I/O as an input or output, see the
Keysight
P9241/42/43A Oscilloscopes Soft Front Panel (SFP) User's Guide
.
Rear Panel Connectors
This section describes the rear panel connectors for the P9241/42/43A
oscilloscope.
Only the USB 3.0 To Host PC and Power rear panel connectors are used by the
P9241/42/43A oscilloscope. The other rear panel connectors are reserved for
future use.
Power
15 VDC, 6A Max
10 MHz
In
10 MHz
Out
Trig
A
Trig
B
To Host PC
USB 3.0
US
B
2.0
host
port
(reserved
for
future
use)
US
B
3
.0
port
for
connection
to
host
PC
T
rigger
I/
O
(reserved
for
future
use)
10
MHz
clock
I/
O
(reserved
for
future
use)
Power
supply
connection
Chassis
ground
Lock
cable
hole
WARNING
A voltage source should never be connected to the ground terminals of this
instrument. If, for any reason, the Protective Conductor Terminal is disconnected or
not functioning properly and a voltage source is connected to the equipment's
ground terminals, the entire chassis will be at the voltage potential of the voltage
source, and the operator or bystanders could receive an electric shock.
Summary of Contents for P9241A
