Quick Start Guide
Preparation for Use
8
Turn On the Signal Generator
Follow this procedure to power on the signal generator:
1
Press the power switch
on the rear panel. The orange
LED will light and the signal generator is in standby mode.
2
Press the standby switch
on the front panel. The green
LED will light.
Self- initialization takes about 30 seconds; the signal
generator then defaults to the menu mode with the
maximum frequency of 3 GHz and minimum amplitude of
–
127 dBm, then the signal generator is ready for your
current use. After power on, let the signal generator warm
up for
45 minutes for stabilization.
N O T E
The front panel switch is a standby switch only; it is not a power
switch. To disconnect the signal generator from the line power, shut
off the power switch on the rear panel.
