Keysight Technologies N4373D, User Manual

Page: 34 / 176

Getting Started
32
Keysight
N4373D Lightwave Component Analyzer, User’s Guide
9. Holding the
adapter with the
spanner wrench,
use the 20mm
torque wrench
from the
calibration kit to
tighten both
connections.
10.Repeat step 3. to
step 9. to connect Port A on
the optical test set to Port 1
on the network
analyzer.
11.Remove the dust cap from the Optical Output.
12.Remove the dust cap from the optical patchcord.
13.Connect the optical patchcord.
14.Repeat step 11. to step 13. for the optical input.
C A U T I O N
If you are using a patchcord with a straight and angled connectors,
make sure you only connect the angled connector (green) to the
optical test set.
C A U T I O N
Always use patchcords to connect to your DUT. This protects the
connectors of the optical test set, by minimizing the number of
connector changes.