N2784/5A Probe Positioners
N2784/5A User’s Guide
9
Probe Angle Adjustment
The angle of your probe can be adjusted by loosening and then tightening three
knobs on the positioner arm/universal holder.
shows the location of these
three knobs. If knobs (1) and (2) are loose, there is a possibility that your probe may
fall over. Make sure these knobs are securely fastened during any measurements.
Knob (3) may be left loose when the probe is used vertically. If the probe is to be used
with some slope against the board then it must be tightened as well.
Figure 6
Location of the three angle-adjustment knobs
on page 10 shows a series of pictures displaying some of the axes that can
be rotated about by loosening and tightening the three knobs shown in
.
CAUTION
During any measurements, always securely tighten knobs (1) and (2) to avoid the
possibility that the probe may fall over.
