Installing N108xA on the 86100D
4
N108xA-Series Getting Started
69
Step 10 (Optional). Add Switching Test Set to Keysight
Connection Expert
The compliance application supports Keysight’s U3020A S26 switching test set and the BitifEye BIT
2100. The following steps illustrate connecting to an Keysight U3020A S26.
1
Locate the switching test set’s IP address and record it on the following line. Refer to the instrument’s
documentation for locating this information.
IP Address: _________________________
2
Open the Keysight
Connection Expert.
3
In Keysight Connection Expert, right click on the
LAN
I/O interface identified in
. Then, click
Add Instrument
.
Figure 68
Adding FlexDCA
4
In the
Add LAN Instruments
dialog box, use the Auto Find feature to locate and select the switching
test set. Click
OK
to close the dialog box.
5
The connection to the switching test set should now be shown in Keysight Connection Expert as
shown in
NOTE
To use a switching test set (switch matrix), you must first install one of the N1081A-7FP, N1082A-7FP, N1083A-7FP,
or N1084A-7FP application licenses.
